Krono xonic Pennsylvania waterproof vinyl flooring

Good question John, there's no need to remove your tiles before laying your flooring.

Hello Eddie, leave the unopened flooring in the room you will be fitting it for 48hrs to allow it to adjust to room temperature. Also, make sure you’ve removed old flooring such as carpets or laminate. Make sure the surface upon which you’ll be laying your flooring is level. There should be no more than a 2mm (0.08 inches) difference per 1m (40 inches) length.

Hi Alan, no you can simply lay the flooring on top of a suitable surface. It contains insulation, so no need for underlay. There's also no need for adhesives or any other type of fixing.

Great question Richard, you’ll need a steel ruler or framing square, a pencil, a carpet cutter or saw, a rubber tapping block and a hammer. Glue may be required, but only if you need to cut and reattach small pieces (for example, where you require holes for radiator pipes). You may also require spacers, but only if laying in a bathroom, new build or where your wall is unfinished.

Your doors may need trimming depending on the current gap between the bottom of your door and the floor minus your current flooring. This flooring is 5mm in height, therefore you can check this before you start.

Great question Stuart, yes it can be used with all types of underfloor heating, however the temperature mustn't exceed 28C.

We would always advise the floor to be level before laying this flooring. Any very minor imperfections should be ok.

This is not suitable for use with a steam cleaner Neil, we’d say warm soapy water is best.

Hi Joyce, the flooring is resistant to scratches, however we would recommend adding floor protector pads to the underside of any chair, table or item of furniture, to help prevent damaging your flooring.